全自動上料攪拌車如何防止粘罐大家知道嗎？ - 行業新聞_新聞資訊-山東山汽工程機械（集團）有限公司

新聞資訊

行業新聞公司新聞

熱點推薦

自上料攪拌車的日常清洗過程

2022-08-30

自上料攪拌車在卸料時的注意事項有哪些？

2022-08-03

自上料攪拌車操作簡單出料迅速

2022-07-06

自上料水泥攪拌車液壓油箱排氣管怎么加水？

2022-06-15

混凝土攪拌車輪胎偏磨是怎么回事？

2022-06-02

造成攪拌車發動機過早損壞的原因有哪些呢？

2022-06-02

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

全自動上料攪拌車如何防止粘罐大家知道嗎？

所屬分類：行業新聞發布時間：2020-06-06 來源：http://www.amerthadana.com 瀏覽量：18

　　從全自動上料攪拌車在日常使用的時候會發現罐體越來越小了,不好清洗材料的原因是卡在槽壁,接下來想為大家介紹的是自上料攪拌車防止粘罐的方法。

　　From the daily use of the full-automatic feeding mixer, it will be found that the tank body is getting smaller and smaller. The reason for the bad cleaning materials is that they are stuck in the tank wall. Next, I want to introduce the method to prevent the tank sticking of the self feeding mixer.

　　1. 隨身攜帶減水劑

　　1. Carry water reducing agent with you

　　減水劑是一種能在保持混凝土坍落度恒定的條件下降低攪拌用水量的混凝土外加劑。但是，在添加減水劑時，一定要記得有商業混凝土站實驗室的存在，否則混凝土質量強度不夠，司機要承擔后果。

　　Water reducing agent is a kind of concrete admixture which can reduce the mixing water consumption under the condition of keeping the concrete slump constant. However, when adding water reducing agent, it is necessary to remember the existence of commercial concrete station laboratory, otherwise the concrete quality and strength are not enough, and the driver shall bear the consequences.

　　2. 檢查水箱里的水量

　　2. Check the water volume in the water tank

　　每次你完成下車任務返回車站時，都要檢查一下水箱里的水。確保水箱里的水在任何時候都是滿的，以備雨天之需。

　　Every time you get off the train and return to the station, check the water in the water tank. Make sure that the water tank is full at all times for rainy days.

　　3.離開工廠前檢查一下混凝土的質量

　　3. Check the quality of concrete before leaving the factory

　　混凝土的質量可能因板材而異，這取決于材料。在加載混凝土離開現場時，要檢查罐內混凝土的坍塌程度和搬運的方便性，小心混凝土的早期凝結和混凝土分層沉淀。

　　The quality of concrete may vary from plate to plate, depending on the material. When the loaded concrete leaves the site, it is necessary to check the collapse degree of the concrete in the tank and the convenience of handling, and be careful of the early setting of the concrete and the layered sedimentation of the concrete.

　　4. 減少車輛行駛時間

　　4. Reduce vehicle driving time

　　混凝土運輸距離一般在直徑30公里以內，根據車輛規劃路線和車輛通行情況，盡量減少車輛在道路上行駛的時間。

　　The concrete transportation distance is generally within 30km in diameter. According to the vehicle planning route and vehicle traffic conditions, the vehicle driving time on the road shall be minimized.

　　5. 減少損耗，先排出物料

　　5. Reduce losses and discharge materials first

　　如果遇到人為因素或不可抗拒的因素，導致長時間無法卸貨的情況，應隨時檢查罐內混凝土情況，一旦發現混凝土開始凝結。卸貨后立即向負責人報告，以防止整個罐內被報廢。

　　In case of artificial or irresistible factors that make it impossible to unload for a long time, the concrete in the tank shall be checked at any time. Once it is found that the concrete starts to set. Report to the person in charge immediately after unloading to prevent the whole tank from being scrapped.

　　以上就是全自動上料攪拌車防止粘罐的方法，我們可以學習后在很大程度上避免這個問題，可以提高自己的工作效率，減少材料的損失。

　　The above is the method to prevent the tank sticking of the full-automatic feeding mixer. We can avoid this problem to a large extent after learning, improve our work efficiency and reduce the loss of materials.

上一頁：多雨的時候如何保養自動上料攪拌機下一頁：全自動上料攪拌機發生側翻的機率有多大？