Because the screen is made of ordinary steel, there are often problems of poor quality and poor wear resistance, and the wrap angle is not reasonable enough. Therefore, it is easy to be damaged in the application process, large-area leakage occurs, and even the mixer can not be used.
In addition, the mesh number of some mixing screens is not scientific enough, and the screening rate is too low, resulting in small particle size of screened sand and stone. If the screen size of the self loading mixer is not reasonable enough and the steel quality does not meet the standard, the most advanced self loading mixer can not mix high-quality concrete.
Wear resistant steel wire should be used in the maintenance of screen fault of self loading mixer truck, set scientific steel wire diameter and screen mesh, appropriately increase the screen area, improve the screening rate and save raw materials, so as to improve the production efficiency. When the screen wire is broken, immediately tighten the screen bolt and reset the screen length.
If the screen blade of the self loading mixer fails, it shall be repaired in time
In addition, blade failure is also a major failure. As one of the important components of the self loading mixer, the blade has a direct impact on the mixing process. The quality of the blade can determine the service life of the self loading mixer to a certain extent. Therefore, in the process of using the self loading mixer, the damage degree of the blade is often high, so we need to pay attention to the blade technology.
After each mixing of the self loading mixer truck, the blades of the self loading mixer truck need to be cleaned immediately in order to clean the dirt on the blades in time. The blades and vibration bearings of the self loading mixer shall be dripping with lubricating oil, and the blades of the self loading mixer shall be rust proof and derusted.
The manufacturer of self loading mixer truck believes that the welding quality of blade handle and blade of self loading mixer truck shall be inspected regularly, and the blade wear and consumption shall be inspected. Once any abnormal problem is found, it shall be recorded and replaced in time, and the conduction state at the bottom of the blade shall be checked to avoid blade damage. Leakage occurs at the solder joint.
The wonderful content of this article is provided by the knowledge of automatic feeding mixer. There are many wonderful contents on this website. You can click to enter more contents: http://www.amerthadana.com/ We have special customer service to answer your questions